Series 3170

Intermediate Cast Overlaminate Pressure-Sensitive Film

Series 3170 overlaminate is a 1.3-mil (35 micron) gloss cast vinyl film with clear, permanent pressure-sensitive adhesive. Designed to protect printed graphics, the thinner facestock of Series 3170 provides a higher conformability for your vehicle wraps, intermediate signage, and graphics. Series 3170 is rated for outdoor durability up to 7 years. This product is not designed to be used as an optically clear window film, or to be used with cast digital films.

Applications & Features

  • Protective overlaminate for CalWrap, DPF 4600LX, DPF 4500GLX/MLX.
  • Vehicle and fleet graphics, intermediate signage, kiosks and POP displays.
  • Arlon overlaminate film is designed to be laminated cold without any heat.

Performance & Physical Data

Property Test Methods Typical Value
Surface Finish Gloss Meter 60º Reflection 80 to 90 Gloss Units
Thickness Micrometer, Federal Bench Type 1.3 mil (35 micron)
Tensile Strength Tensile Tester with 2-in (51 mm) jaw separation; crosshead speed of 12 in/min. (5.1 mm/s), web direction ≥ 6.5 lb/in ≥1.2 kg/cm
Elongation Instron Tensile Tester as above ≥ 200%
Shelf Life (In Box) Ideal Storage Temperature 70ºF (21ºC) and 50% relative humidity 2 years from factory shipment
Application Temperature Range On clean, dry substrate
Application Temperature Range Flat: 40ºF to 100ºF 4.4ºC to 38ºC
Application Temperature Range Corrugated with rivets & channels: 60ºF to 100ºF 15ºC to 38ºC
Service Temperature Range On clean, dry substrate: -40ºF to 175ºF -40ºC to 79ºC
Dimensional Stability Shrinkage after 158ºF (70ºC), 48 hours <10-mil 0.25 mm
Peel Adhesion PSTC-1, 15 min, 70ºF (21ºC) 3.0 lbs/in 0.535 kg/cm
Liner Release TLMI Release at 90º, 300 in/min (760 cm/min) 37 g/2in 7.28 g/cm
Standard Terms & Conditions Apply

TERMS & CONDITIONS

The following is made in lieu of all warranties expressed or implied:

All statements, technical information and recommendations published by Arlon relating to Arlon products are based on tests believed to be reliable and within the accuracy of the equipment used to obtain the specific values. Their accuracy or completeness is not guaranteed and Arlon makes no warranty with regard thereto. Seller’s and manufacturer’s only responsibility shall be to replace any quantity of the product proved defective. Seller and manufacturer shall not be liable for injury, loss or damage, direct or consequential, arising out of use or the inability to use the product. Nor shall seller or manufacturer be liable for any costs or expenses incurred in the processing or printing on the product. Before using, user shall determine the suitability of the product for its intended use. User assumes all risk and liability of every nature in connection therewith. No statements or recommendations other than those contained in the technical information published by Arlon shall have force or effect unless contained in an agreement manually signed by the officers of seller and manufacturer.

Copyright © Arlon Graphics, LLC. All Rights Reserved.