How to Install on Rivets - Roller Methods (#50)

Tunnel Methods

1. Remove release liner and drape the whole panel on the surface.
   
    
2. With a squeegee, apply the flat areas first, leaving a continuous tunnel of air approximately the width of the rivets.
   
    
3. Heat a section of film which covers 4-5 rivets. As you apply heat, the film will wrinkle but will flatten out once it reached its optimum temperature (180°F to 240°F).
   
    
4. Using a foam roller applicator, apply firm pressure over 3-4 rivets at a time. Going over too many rivets at a time may result in tenting because of the film cooling down.
   
    
5. Repeat Steps 3 and 4 until you finish the entire column of rivets and then move on to the next set.
      
    
6. Post-heat the film on the rivets to 200°F to 220°F (95°C to 105°C) because the foam roller tends to leave a rough texture.
   

Rivet-First Method

1. Remove release liner and drape the whole panel on the surface.
   
    
2. Heat a section of film which covers 4-5 rivets. As you apply heat, the film will wrinkle but will flatten out once it reaches its optimum temperature (180°F to 240°F).
   
    
3. Using a foam roller applicator, apply firm pressure over 3-4 rivets at a time. Going over too many rivets at a time may result in tenting because of the film cooling down.
   
    
4. Repeat Steps 2 and 3 until you finish the entire column of rivets and then move on to the next set.
      
    
5. With a squeegee, carefully apply the flat areas last.
      
   
   TIP: Use light squeegee pressure during the first pass to avoid trapping bubbles in the flat areas.
    
6. Post-heat the film on the rivets to 200°F to 220°F (95°C to 105°C) because the foam roller tends to leave a rough texture.
   
    

Don't See What You're Looking For?

Many of these TIPS come from our customer feedback and questions so be sure to reach out to us so that we can help you and in turn help others as well! Arlon Technical Services is here for you.

Contact Customer Service