How to Install on Rivets - Roller Methods (#50)

Tunnel Methods

1. Remove release liner and drape the whole panel on the surface.
   
    
2. With a squeegee, apply the flat areas first, leaving a continuous tunnel of air approximately the width of the rivets.
   
    
3. Heat a section of film which covers 4-5 rivets. As you apply heat, the film will wrinkle but will flatten out once it reached its optimum temperature (180°F to 240°F).
   
    
4. Using a foam roller applicator, apply firm pressure over 3-4 rivets at a time. Going over too many rivets at a time may result in tenting because of the film cooling down.
   
    
5. Repeat Steps 3 and 4 until you finish the entire column of rivets and then move on to the next set.
      
    
6. Post-heat the film on the rivets to 200°F to 220°F (95°C to 105°C) because the foam roller tends to leave a rough texture.
   

Rivet-First Method

1. Remove release liner and drape the whole panel on the surface.
   
    
2. Heat a section of film which covers 4-5 rivets. As you apply heat, the film will wrinkle but will flatten out once it reaches its optimum temperature (180°F to 240°F).
   
    
3. Using a foam roller applicator, apply firm pressure over 3-4 rivets at a time. Going over too many rivets at a time may result in tenting because of the film cooling down.
   
    
4. Repeat Steps 2 and 3 until you finish the entire column of rivets and then move on to the next set.
      
    
5. With a squeegee, carefully apply the flat areas last.
      
   
   TIP: Use light squeegee pressure during the first pass to avoid trapping bubbles in the flat areas.
    
6. Post-heat the film on the rivets to 200°F to 220°F (95°C to 105°C) because the foam roller tends to leave a rough texture.
   
    

Nicht gefunden wonach Sie suchen?

Viele dieser Tipps sind direktes von unseren Feedback von unseren Kunden, also kontaktieren Sie uns gerne, damit wir Ihnen helfen und wiederum anderen helfen können! Der technische Support von Arlon ist für Sie da.

Kundenservice kontaktieren